Gates of Arimyth
http://forum.arimyth.com/

a1 merc ias with CC,breakpoints
http://forum.arimyth.com/viewtopic.php?f=10&t=1025		 Page 1 of 1
Author:  blinky99 [ Wed Feb 03, 2010 2:21 pm ]
Post subject:  a1 merc ias with CC,breakpoints
i rolled a 464ed 40ias CC and thought death knight gives max IAS, pluse im using faith, what are the break points or do i not need the IAS on the bow?

A1 phys merc
Author:  blinky99 [ Wed Feb 03, 2010 10:58 pm ]
Post subject:  Re: a1 merc ias with CC,breakpoints
Frames---16 FPS---15 FPS---14 FPS---13 FPS---12 FPS---11 FPS---10 FPS---9 FPS
WBS(-10)---0 IAS----0 IAS----0 IAS----7 IAS----18 IAS----35 IAS-----60 IAS---109 IAS
WBS (0)----0 IAS----0 IAS----9 IAS----19 IAS----32 IAS----54 IAS----86 IAS---152 IAS
WBS (5)----0 IAS----6 IAS---15 IAS----26 IAS---40 IAS----65 IAS----102 IAS---180 IAS
WBS (10)---5 IAS---11 IAS---22 IAS---34 IAS---50 IAS---78 IAS-----120 IAS---215 IAS


I found this table at some site does it hold true?
Author:  blue_myriddn [ Thu Feb 04, 2010 12:17 am ]
Post subject:  Re: a1 merc ias with CC,breakpoints
to be honest - I am not sure you are going to find an answer with A1 mercs and crossbows. My personal theory is that the D2 engine can't distinguish between a bow and an xbow for A1 mercs and uses the same breakpoints for both which would be a huge benefit for the merc. I can't confirm this well though as mercs don't seem to fire consistently.
Author:  PureRage-DoD [ Thu Feb 04, 2010 1:14 pm ]
Post subject:  Re: a1 merc ias with CC,breakpoints
they use the same breakpoints as a hydra bow as far as I know, so check the speed with an ias calculator for a hydra bow
Author:  Cory [ Thu Feb 04, 2010 2:52 pm ]
Post subject:  Re: a1 merc ias with CC,breakpoints
With level 10 fanta (if using a faith stick on ur nec) its

0% = 13
6% = 12
20% = 11
40% = 10
78% = 9
Author:  FuryCury [ Thu Feb 04, 2010 4:30 pm ]
Post subject:  Re: a1 merc ias with CC,breakpoints
Kannli can correct me if Im wrong, but I believe lvl 10 HU fanat is the same as lvl 26 bnet fanat. This should give a more accurate ias table when using the calculators.
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/